Error Code 0C0032 (Continuable)


Problem Description:

Drop Detector not calibrated or the calibration settings have been lost.

Corrective Action:

Try the following:

1. Perform the EEROM Backup from the HDD to the Main PCA(select Main PCA replaced).

2. Switch the printer Off and ON again.

3. If the System Error Code continues:

– Perform the Service Station Calibration.

– Replace the Drop Detector Assembl.

– Replace the Service Station Assembly.

Warning:

Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed.

This entry was posted in Error Codes, HP DesignJet 5000. Bookmark the permalink.