Author Archives: jgubow

Error Code 41:YZ

Posted on July 8, 2013 by jgubow

Problem Description: Electrical fault or current limit in Media-Axis Motor Corrective Action: Try the following: 1. Switch the power off from the back of the printer and disconnect the power cord. Reconnect the power cord and power on the printer. … Continue reading →

Posted in Error Codes, HP DesignJet T770 | Comments Off on Error Code 41:YZ

Error Code 39.2:01

Posted on July 8, 2013 by jgubow

Problem Description: Roll 2 switch failed (standby or resume). Roll 2 has been unloaded. Corrective Action: There is no corrective action. This system warning code only notifies the user that the roll has been unloaded because an unexpected error occurred … Continue reading →

Posted in Error Codes, HP DesignJet T770 | Comments Off on Error Code 39.2:01

Error Code 0B000E

Posted on July 8, 2013 by jgubow

Problem Description At power-up, the Printer thinks it is smaller than 42 inches. Corrective Action Try the following: 1. Check that there are no obstacles in the Scan-Axis which stops the Carriage from reaching the end-stops on both sides. 2. … Continue reading →

Posted in Error Codes, HP DesignJet 5500uv | Comments Off on Error Code 0B000E

Error Code 06040C

Posted on July 8, 2013 by jgubow

Problem Description: Line Sensor not connected correctly. Corrective Action: Try the following: 1. Check/reconnect the Line Sensor. 2. Replace the Line Sensor. 3. Replace the Carriage Assembly. Warning: Only replace one component at a time and check if the error … Continue reading →

Posted in Error Codes, HP DesignJet 5500 | Comments Off on Error Code 06040C

Error Code 39.1:01

Posted on July 8, 2013 by jgubow

Problem Description: Roll 1 switch failed (standby or resume). Roll 1 has been unloaded. Corrective Action: There is no corrective action. This system warning code only notifies the user that the roll has been unloaded because an unexpected error occurred … Continue reading →

Posted in Error Codes, HP DesignJet T770 | Comments Off on Error Code 39.1:01

Error Code 26:01

Posted on July 2, 2013 by jgubow

Problem Description: Ink supply error found during IDS diagnostic test. In the front panel message you will see letters representing the names of the colors of the faulty supplies. Corrective Action: Try the following: 1. Reseat the faulty ink supply … Continue reading →

Posted in Error Codes, HP DesignJet T770 | Comments Off on Error Code 26:01

Error Code 24:YZ

Posted on July 2, 2013 by jgubow

Problem Description: Ink Setup failure Corrective Action: Try the following: 1. Switch the power off from the back of the printer and disconnect the power cord. Insert the new purgers, reconnect the power cord and power on the printer. 2. … Continue reading →

Posted in Error Codes, HP DesignJet T770 | Comments Off on Error Code 24:YZ

Error Code 22.1:YZ

Posted on July 2, 2013 by jgubow

Problem Description: Left Ink Supply Station error, module 1 Corrective Action: Try the following: 1. Switch the power off from the back of the printer and disconnect the power cord. Reconnect the power cord and power on the printer. 2. … Continue reading →

Posted in Error Codes, HP DesignJet T770 | Comments Off on Error Code 22.1:YZ

Error Code 22.0:YZ

Posted on July 2, 2013 by jgubow

Problem Description: Left Ink Supply Station error, module 0. Corrective Action: Try the following: 1. Switch the power off from the back of the printer and disconnect the power cord. Reconnect the power cord and power on the printer. 2. … Continue reading →

Posted in Error Codes, HP DesignJet T770 | Comments Off on Error Code 22.0:YZ

Error Code 21.2:YZ

Posted on July 2, 2013 by jgubow

Problem Description: Failure testing the length of the Service Station path Corrective Action: Try the following: 1. Switch the power off from the back of the printer and disconnect the power cord. Check the Primer Tubes. Reconnect the power cord … Continue reading →

Posted in Error Codes, HP DesignJet T770 | Comments Off on Error Code 21.2:YZ