Error Code 21.2:YZ


Problem Description:

Failure testing the length of the Service Station path

Corrective Action:

Try the following:

1. Switch the power off from the back of the printer and disconnect the power cord. Check the Primer Tubes. Reconnect the power cord and power on the printer.

2. Make sure that the Service Station path is clear. Remove any visible obstacles (screws, plastic parts, etc.) restricting the movement of the Service Station.

3. If the carriage has stopped over the service station, on the right side of the printer, check that the cutter is not activated. It may happen that the cutter is blocking the carriage over the service station, preventing the service station from performing the movement correctly. The cutter is on the left side of the carriage.

4. Perform the Service Station diagnostic test to troubleshoot the problem further.

5. Replace the Service Station.

This entry was posted in Error Codes, HP DesignJet T770. Bookmark the permalink.