Error Code 01:13

Problem Description:

Electronics Module failure. The possible cause could be:

1. One of the ASIC’s in the Electronics Module is reporting that it is too hot.

2. The interruptions from the Scan-Axis servo or from the Paper-Axis servo are not coming as regularly as they are expected or are coming too late.

Corrective Action:

Try the following:

1. Switch the Printer Off and wait a few minutes. Switch the Printer On again and check if the Error Code has disappeared.

2. If the Error Code continues, replace the Electronics Module

This entry was posted in Error Codes, HP DesignJet 800. Bookmark the permalink.