Error Code 73:04

Problem Description:

Servo Error.

Corrective Action:

Try the following:

1. Switch the Printer Off and wait a few minutes. Switch the Printer On again and check if the Error Code has disappeared.

2. If the Error Code reappears, check for a new Firmware release.

3. If the new Firmware release does not solve the problem then replace the Electronics Module.

4. If the problem continues, contact the HP Response Center (or directly to the Division) supplying the following information:

– Model and Serial Number of the Printer.

– Firmware release of the Printer (use the Printer Information utility).

– The complete Error Code information, including the linefeed where the error occurred (use the Error Log utility to obtain this information).

This entry was posted in Error Codes, HP DesignJet 800ps. Bookmark the permalink.